You're a Peach DSP Box

Updated: Aug 2, 2021

Supply List

[Annual Catalog 21-22]

Cutting Measurements

Directions

Box: (Size: 3-3/4” x 6-1/2”)

1. Cut You’re a Peach DSP 10-1/4” x 8-1/2”

2. On 10-1/4” side, Score 3-3/4”; 4-3/4”; 8-1/2”; 9-1/2”

On 8-1/2” side, Score 1” for bottom of Box

3. Fold on Score Lines & burnish with Bone Folder

4. Cut up Score lines at the bottom, cutting off small corner

Adhering Sides:

1. Place Box flat with wrong side of DSP facing upward

Add Tear & Tape along the narrow edge on the front side & remove backing

2. Fold Box inward at the second Score line

Fold the other side over, line up score lines & adhere Box together

Adhering Bottom:

1. Stand Box upside down with the side seam facing you (this is the back of the Box)

Fold the flap facing you inward

2. Add Tear & Tape on the wrong side of the DSP on both corners & the opposite flap &

remove backing;

Fold the side flaps inward & adhere

Fold the opposite flap inward & adhere

(Note: For a clean look, all seams should face the back of the Box)

Tag:

1. Die Cut Calypso Coral Cardstock scrap with third smallest Rectangle Die from

Scalloped Contour Dies with Stampin’ Cut & Emboss

2. Die Cut Basic White Cardstock scrap with second smallest Rectangle Die from

Scalloped Contour Dies with Stampin’ Cut & Emboss

3. Stamp “Thank you for Everything” from Color & Contour Stamp Set in Old Olive Ink

4. Adhere two Die Cuts together with Tombow

5. Fussy Cut Peach & Leaves from You’re a Peach DSP with Paper Snips;

Adhere with Mini Glue Dots & Stampin’ Dimensionals

6. Add Genial Gems to Tag

Finishing Up:

1. Punch a hole through front & back of the Box with Hole Punch

2. Add choice of Gift to inside of Box

3. Thread Ribbon & Twine from back to front of Box, insert Tag & tie in a bow

Cleaning Stamps:

1. Run Shammy under warm water until soft & wring out excess water

2. With Stamp on Clear Block, rub Stamp onto Shammy until clear of Ink

3. Store Shammy in Clear Case & leave open when wet

Recent Posts