Pansy Petals DSP for Cute Valentine's Candy Box

Updated: Feb 8, 2022

Box Size: 2-3/4” x 5-1/2”

Supply List

(Annual Catalog 2021-22)

(Other)

Cutting Measurements:

Directions

Box:

1. Cut Pansy Petals DSP 8” x 6-1/2”

2. On 8” side Score 1-3/4; 2-3/4; 5-1/2; 6-1/2

On 6-1/2” side Score 1” for the bottom

3. Fold on Score lines & burnish with Bone Folder

4. Cut up bottom Score Lines with Paper Snips

5. Lay DSP flat with wrong side facing upward

6. Add two strips of Tear & Tape to the center bottom rectangle on the wrong side,

leaving on the backing;

Add a strip of Tear & Tape to the right side edge from the top to the bottom

on the wrong side;

Rune Bone Folder over Tear & Tape to secure;

Remove Tear & Tape backing from the side only;

Fold left side over at the first fold; Fold the other side over & adhere sides together

Adhering Bottom of Box:

1. Turn Box upside down with back seam facing you;

2. Add Stampin’ Seal + to the inside of both small side bottom edges

3. Remove the Tear & Tape backing on the center rectangle

4. Fold the center facing you inward; Fold in both sides;

Fold over the remaining rectangle & adhere

5. Run Bone Folder inside bottom of Box to firmly secure

(Note: For a cleaner look, both seams will be the Back of the Box)

Tag:

1. Punch reverse side of Pansy Petals DSP with smaller Heart Punch;

2. Stamp “Love” from Sending Hearts Stamp Set with Calypso Coral Ink

3. Punch Highland Heather Cardstock with Scalloped Heart Punch;

4. Adhere together with Stampin’ Dimensionals

5. Add Heart embellishment from Sending Hearts Paper Pumpkin K

Finishing Up:

1. Insert Valentine Candy Box

2. Pinch top sides together & Hole punch top center with Hole Punch

3. Thread Ribbon through hole from the back to the front & tie;

insert Tag & tie in a bow to close

Cutting Measurements:

Recent Posts