All images © 2016-2021 Stampin’ Up!®
Supply List
[Annual Catalog 21-22]
Color & Contour Bundle [158356]
Color & Contour Stamp Set
Scalloped Contours Dies
Hand-Penned DSP [155499]
Basic White Cardstock [159276]
Pale Papaya Cardstock [155668]
Pale Papaya & White Ribbon [155816]
Memento Black Ink [132708]
Genial Gems [155500]
Bone Folder [102300]
Paper Snips [103579]
Clear Block D [118485]
Paper Trimmer [152392]
Stampin’ Cut & Emboss [149653]
Multipurpose Liquid Glue (Tombow) [110755]
Stampin’ Dimensionals [104430]
Stampin’ Seal + [149699]
Simply Shammy [147042]
Tear & Tape [154031]
Hole Punch
Gift: Classic Stampin’ Pad
Measurements
Hand-Penned DSP 10-1/4” x 8-1/2” for box
Hand-Penned DSP 3-5/16” x 2-1/16 for tag
Basic White Cardstock 3-1/2” x 2” for tag
Pale Papaya Cardstock 4” x 2-3/4” for tag
Pale Papaya & White Ribbon 17”
Directions
Bag: (Bag Size: 3-3/4” x 6-1/2”)
1. Cut Hand-Penned DSP 10-1/4” x 8-1/2”
2. On 10-1/4” side, Score 3-3/4”; 4-3/4”; 8-1/2”; 9-1/2”;
3. On 8-1/2” side, Score 1” for bottom of Box
4. Fold on Score Lines & burnish with Bone Folder;
5. Cut up Score lines at the bottom, cutting off small corner
Adhering Sides:
1. Add Tear & Tape along the narrow edge on the front side
2. Turn Box over with the inside facing upward; remove Tear & Tape backing;
fold the side with the adhesive at the second Score line inward;
fold the other side over, lining up sides & adhere together
Adhering Base:
1. Add Tear & Tape on the inside of the Box of the two side flaps & seam side flap
2. Stand Box upside down with the seam facing you (this is the back of the Box)
Remove Tear & Tape backing on the side flaps;
Fold the front flap inward then the side flaps to adhere
3. Remove Tear & Tape backing on remaining side & adhere bottom of Box
(Note: For a clean look, adhere Box so all seams face the back of the Box)
Tag:
1. Cut Pale Papaya Cardstock 4” x 2-3/4”; Die Cut with 3-3/4” x 2-1/2” Rectangle Die from
Scalloped Contour Dies with Stampin’ Cut & Emboss
2. Cut Hand-Penned DSP 3-5/16” x 2-1/16 & adhere with Tombow
3. Cut Basic White Cardstock 3-1/2” x 2”; Die Cut next smallest Rectangle Die from
Scalloped Contour Dies with Stampin’ Cut & Emboss
4. Stamp “Thank you for Everything” from Color & Contour Stamp Set in
Memento Black Ink & adhere with Tombow
5. Fussy Cut Flowers & Leaves from Hand-Penned DSP with Paper Snips & adhere with
Stampin’ Seal + & Stampin’ Dimensionals
6. Add Genial Gems to Tag
Finishing Up:
1. Punch a hole through front & back of the Box with Hole Punch;
2. Insert choice of Gift
3. Thread Pale Papaya & White Ribbon from back to front & through Tag; tie in a bow
Cleaning Stamps:
1. Run Shammy under warm water until soft & wring out excess water
2. With Stamp on Clear Block, rub Stamp onto Shammy until clear of Ink
3. Store Shammy in Clear Case & leave open when wet
Comments