All images © Stampin’ Up! ®
Supplies:
Designer Series Paper (DSP): Favored Flowers
Cardstock: Petal Pink
Dies: Round We Go
Adhesive: Liquid Glue; Mini Glue Dots; Tear & Tape
Tools: Bone Folder; Paper Snips; Paper Trimmer; Stampin’ Cut & Emboss
Embellishments: Coordinating Clips, Ribbon, Sequins
Directions:
Box:
1. Cut DSP 9-1/2” x 6”
2. On 9-1/2” side, Score 3-1/4” - 4-1/2” - 7-3/4” - 9”;
On 6” side, Score 1-1/4” for the bottom
3. Fold on all Score lines & Burnish with Bone Folder
4. Cut up all bottom Score lines to Score Line; cutting off small corner
Adhering Box:
1. To adhere the sides, lay the Box flat with the inside facing upward;
Fold over the side with the narrow edge;
Add Tear & Tape along the narrow edge of the front side;
Fold over the other side to adhere sides together
2. To adhere the bottom, add Tear & Tape to the inside bottom front & sides only,
(leaving the bottom back where the side seam is without adhesive)
Fold the back (with no adhesive) inward, then the sides & front to adhere the bottom
3. Turn Box right side up & burnish the inside bottom with the rounded end of
Bone Folder to securely adhere the bottom of the Box
Sentiment:
1. Die Cut largest Circle Die with Petal Pink Cardstock
Die Cut smaller Circle Die from coordinating DSP
2. Center & adhere Circles together with Liquid Glue
3. Fussy Cut Flower & Leaves from same DSP
Layer & adhere Leaves to back of Flower with Mini Glue Dots
4. Adhere Flower to inner Circle with Stampin’ Dimensionals
5. Adhere Circle to the Box Front with Liquid Glue
Finishing Up:
1. Add coordinating sequin to center of Flower
2. Add a scrap piece of Ribbon to Clip, trim Ribbon & close Box at the top
Comentarios