Search

Let it Snow Ornament


All images © 2016-2019 Stampin’ Up!®

Supply List:

Let it Snow Suite [153386]

Let It Snow Speciality Designer Series Paper (SDSP) [150393]

Real Red Curly Ribbon [150426]

Paper Trimmer [152392]

Small Clear Christmas Bulb

Pencil

Measurements:

Let it Snow SDSP 1/2” x 10”

Directions:

1. Remove top from clear Bulb

2. Cut 8 - 10 Let it Snow SDSP strips 1/2” x 10”, two of each design

3. Place the end of one strip around a pencil, rolling pencil while tightly rolling the SDSP

until the strip is fully rolled, pulling end of paper to tighten roll

(Tip: Be sure the rolled strip fits in the top hole of the Bulb)

4. Remove pencil & drop tightly rolled strip inside the bulb, shake the bulb to loosen the SDSP

5. Repeat using the reversed side of the SDSP & continue with the remaining two sided SDSP

6. Insert bulb top & add Ribbon

CASE: Beneath My Heart Home Decor (Pinterest)


0 views

Kathy W. McDaniel. All Rights Reserved - Images © 2020 - 2016 Stamping' Up! ® 

Kathy W. McDaniel is an Independent Stamping' Up! Demonstrator and is responsible for the content of this website.