Easel Card Glow of Harvest

_{All images © Stampin’ Up! ®}

Finished Size: 4-1/2” x 4-1/2”

Supplies;

Stamps: Framed Violets

Cardstock: Basic White; Pecan Pie

DSP: Glow of Harvest

Ink: Pecan Pie

Adhesive:  Liquid Glue; Mini Glue Dots; Stampin’ Dimensionals

Tools:  Bone Folder; Paper Snips; Paper Trimmer

Embellishments: Any coordinating gems or sequins

Directions:

Card Base:

1. Cut Pecan Pie Cardstock 4-1/4” x 8-/12;

Score on 8-1/2” side at 2” & 4-1/4”

Easel Card:

1. Cut Pecan Pie Cardstock piece 4-1/4” x 4-1/4”

2. Place Base Card with the inside facing upward & the Score Lines at the top

3. Add Tear & Tape along the top inside above the Score line

4. Adhere Cardstock piece with Liquid Glue, lining up all edges (this is the Card Front)

Card Front:

1. Cut Basic White Cardstock 4” x 4”; (cut 2, one for inside Card)

Cut Glow of Harvest DSP 3-1/2” x 3-1/2”

2. Center & adhere to Card Front with Liquid Glue

Bottom Inside Card:

1. Center & adhere Basic White 4” x 4” piece to the bottom inside with Liquid Glue

2. Cut Glow of Harvest DSP strip 4” x 1-1/4”;

Center & adhere strip along the bottom of the Basic White with Liquid Glue

Sentiment:

1. Cut Basic White 3-1/2” x 3/4”;

Cut out a banner look on the right end with Paper Snips

2. Stamp “I appreciate You” in Pecan Pie Ink;

Adhere to Card front at an angle with Stampin’ Dimensionals

3. Add coordinating gem or sequins

Finishing Up:

1. Fussy Cut Flowers, Leaves & Pumpkin from DSP;

Adhere to Card front with Stampin’ Dimensionals & Mini Glue Dots

Envelope:

1. Cut DSP 6” x 2-1/2”

2. Add Liquid Glue to the outside of the Envelope flap;

Place coordinating DSP over the flap, lining up along the fold line;

3. Run Bone Folder over the flap to secure;

Trim around the DSP edge with paper snips 

Note:  To easily stand the Easel Card in place, close the card & press lightly over the front;

the front will then easily slide into the bottom to hold it upright.

(Easel Card design by Splitcoasters - Beate)