Nov 7, 20192 min read

Let it Snow Ornament Gift Box

Supply List:

Measurements:

Blueberry Bushel Cardstock (box base): 8 1/4” x 8 1/4”; scored: 2 3/4” all sides
Blueberry Bushel Cardstock (box lid): 6 1/8” x 6 1/8”; scored 1 5/8” all sides
Let it Snow Speciality Designer Series Paper: 2 3/4” x 1 3/8” (cut 4)
Let is Snow Specialty Designer Series Paper: 2 5/8” x 2 5/8” (cut 1)

Directions:

Box Base:

1. Cut Blueberry Bushel Cardstock 8 1/4” x 8 1/4”; Score at 2 3/4” all sides; fold using Bone Folder

2. Cut Score lines on one end to score line; slightly bevel (cut at an angle) on both sides;

repeat on opposite end of Cardstock

3. Adhere Tombow to four corners on the right side of Cardstock; folding corners inward to adhere

Box Lid:

1. Cut Blueberry Bushel Cardstock 6 1/8” x 6 1/8”; Score 1 5/8” all sides; fold using

Bone Folder

2. Cut Score lines on one end to score line; slightly bevel (cut at an angle) on both sides;

repeat on opposite end of Cardstock

3. Adhere Tombow to four corners on the right side of Cardstock; fold corners inward to adhere

Box Lid Design:

1. Cut four Let it Snow SDSP 2 3/4” x 1 3/8” & adhere to sides of Lid with Tombow

2. Cut one Let it Snow SDSP 2 5/8” x 2 5/8”; flip SDSP over & adhere to top of Lid with Tombow

3. Cut Real Red Glimmer Paper 3 3/4” x 3/4”; Punch on both ends with Banner Triple Punch & adhere to Lid with Tombow

Snowman:

1. Stamp Snowman on Whisper White Cardstock in Memento Black Ink

(Tip: there is only one Snowman in the Stamp Set that coordinates with the Punch)

2. Punch out with Snowman Builder Punch

3. Punch Hat from Real Red Glimmer Paper

4. Cut Washi Tape to fit Hat, cut in half & adhere to Hat; add Black Enamel Shape

5. Punch Hands from Early Espresso Cardstock or adhere Hands from the

Embellishment kit

6. Adhere Snowman to Lid with Stampin’ Dimensionals

(Optional): Add small dots of Puff Paint to top of Lid; Heat with Heat Tool until puffed up)

Recent Posts