top of page
Search

Christmas Ornament with Curled DSP

Cutting Up with Kathy

Supplies:

Clear Christmas Bulb, any size

Designer Series Paper Two-Sided

Paper Trimmer

Ribbon

Pencil

Directions:

1. Remove top from clear Bulb

2. Cut 10-12 Strips 1/2” x 10” of a variety of two-sided Christmas DSP,

cutting two of each pattern

(optional: cut a few variety of widths)

3. Place one end of a Strip around Pencil,

continue rolling Pencil while holding Strip tightly until Strip is fully rolled;

pull out pencil, while holding Strip tightly

4. Drop tightly rolled Strip inside Bulb

5. Repeat with opposite side of second Strip with same design

6. Continue until Bulb is filled with rolls of designer paper,

slightly shaking bulb throughout the process

7. Attach top to clear Bulb

8. Add ribbon through hold & tie in bow


4 views0 comments

Recent Posts

See All

Kathy W. McDaniel. All Rights Reserved - Images © 2016 - 2025 Stamping' Up! ® 
Kathy W. McDaniel is an Independent Stamping' Up! Demonstrator and is responsible for the content of this website.  

bottom of page